The designing of algorithms for real-time digital simulation of analog effects and amplifiers brings two contradictory requirements: accuracy versus computational efficiency. In this paper, the simulation of a typical ...

As NS-3 simulator does not support the direct mapping of Triple Play services into T-CONT and their labeling. We focus on a delay value for Triple Play services which was reduced by own modification in a GIANT algorithm. ...

The study is focused on evaluation of different types of prototypes of automatics for additional faulted phase earthing (FPE), which are used for earth fault (EF) current reduction in resonant earthed distribution network. ...

This paper discusses the smart energy model of a smart grid using a significant share of renewable energy sources combined with intelligent control that processes information from a smart metering subsystem. An algorithm ...

This paper presents results of such a simulation study. It is based on realistic PLC channel model implementation in Network Simulator 3, our modification and extension of this implementation for our use case scenario. It ...

Passive optical networks are dominating access networks around the world due to its their economical aspect, bandwidth, and penetration. It is necessary to deal with specification of these networks.

The paper describes an application of numerical simulation of fire dynamics and evacuation of people in a tunnel. The software tool Fire Dynamics Simulator is used to simulate temperature resolution and development of smoke ...

In this article we discuss validation of selected microscopic traffic models, based on the comparison of simulated vehicle dynamics with observed dynamic characteristics of vehicles recorded by the precise geodetic GPS equipment.

High pressure descaling nozzles are used mainly for removing oxides from hot steel products. The homogeneity and intensity of water pressure distribution on the oxidised surface are very important characteristics for a ...

Efficiency of reciprocating compressor is strongly dependent on the valves characteristics, which affects the flow through the suction and discharge line. Understanding the phenomenon inside the compressor is necessary ...