The objective of this paper is to design and produce a robot based on a four wheel chassis equipped with a robotic arm capable of manipulating small objects. The robot should be able to operate in an autonomous mode ...

This work deals with the design and manufacture of the device, which is used as a shooting range to practice shooting with an air gun. The device is controlled by the Arduino MEGA and could be connect to any number of smart ...

The aim of this thesis is to present possible technical solution for monitoring sports activity. Electric signals of heart are transmitted into an open-source Arduino platform and results are presented to the user in a ...

The aim of this work is to construct a two-legged wirelessly controlled walking robot. This paper describes the construction of the robot, its control electronics, and the solution of the wireless control. The article also ...

This article describes a development of device used for capturing data from different serial buses such as SPI, UART and I2C. Device is design as shield to support Arduino boards. The Shield includes four fully isolated ...

During fMRI acquisition of task related data the variability of time lag between the audio stimulus demand and its actual playback causes a huge problem for precise data analysis. The lag is probably arised because of using ...

This work deals with the design and manufacture of the AC wattmeter. It is controlled by the Arduino Nano and could be connected to 3 phase AC system. It is designed to be included in the DIN rail of the house central ...

The tomograph prototype based on visible light is devised and built in this paper. The propose of software for object scanning and data evaluation was included too. The principles of medical tomographs were used for prototype ...

The purpose of this thesis is to construct a two-legged walking robot. This robot will be able to walk forward independently, following a given trajectory without any human assistence. The whole thesis includes the design ...

This article deals with ECG acquisitions and analysis for laboratory studies. Proposed algoritmhs are realized in Matlab and Arduino workspace. Output this project is device for acquisitions ecg from isolated rodent heart.