Multifunction RF Filters Using OTA
Multifunkčí RF filtry s OTA zesilovači
Abstract
In this paper the procedure of RF filter design using two active elements OTA is shown. The general method of filter design using OTA amplifiers, when the fully connected feedback network was designed around the two OTA elements, is shown. Autonomous circuits were gradually picked out from this general arrangement, using two to five passive elements. These autonomous circuits then serve as an initial circuit in designing different types of frequency filters. On a selected autonomous circuit, all the procedure of multifunction filter design is shown. The properties of the proposed second-order multifunction filter were subjected to an AC analysis in the PSpice software, a generalized sensitivity analysis and experimental measurement. V tomto článku je ukázán postup návrhu RF filtrů se dvěma aktivními prvky OTA. Na vybraném autonomním obvodu je ukázán celý návrhový proces řešení multifunkčního filtru.
Keywords
OTA, kmitočtový filtr, autonomní obvod, obecná admitanční síť, citlivostní analýza, OTA, frequency filter, autonomous circuit, general admittance network, sensitivity analysisPersistent identifier
http://hdl.handle.net/11012/70256Document type
Peer reviewedDocument version
PostprintSource
Mobile and Wireless Communication Networks. 2007, vol. 245, issue 1, p. 557-568.https://link.springer.com/chapter/10.1007%2F978-0-387-74159-8_55
Collections
- Ústav telekomunikací [341]