Zobrazují se záznamy 1-4 z 4
Elastic and Plastic Behavior of the QE22 Magnesium Alloy Reinforced with Short Saffil Fibers and SiC Particles
(MDPI AG, 2018-02-15)
Magnesium alloy QE22 (nominal composition 2 wt % Ag, 2 wt % mixture of rare earth elements, balance Mg) was reinforced with 5 vol % Saffil fibers and 15 vol % SiC particles. The hybrid composite was prepared via the squeeze ...
Effect of heat treatment on mechanical properties and residual stresses in additively manufactured parts
(Institute of Theoretical and Applied Mechanics of the Czech Academy of Sciences, 2018-05-14)
Heat treatments commonly used for post-processing in additive manufacturing (AM) deal with relieving residual stresses. However, generally these treatments reduce strength properties of material such as yield stress (YS) ...
Selective Laser Melting Strategy for Fabrication of Thin Struts Usable in Lattice Structures
This paper deals with the selective laser melting (SLM) processing strategy for strut-lattice structure production which uses only contour lines and allows the porosity and roughness level to be managed based on ombination ...
Influence of Scanning Strategies on Processing of Aluminum Alloy EN AW 2618 Using Selective Laser Melting
This paper deals with various selective laser melting (SLM) processing strategies for aluminum 2618 powder in order to get material densities and properties close to conventionally-produced, high-strength 2618 alloy. To ...