Příprava a charakterizace nanostruktur
Browse by
Recent Submissions
-
Memristors with Initial Low-Resistive State for Efficient Neuromorphic Systems
(Wiley, 2022-03-21)Memristive electronic synapses are attractive to construct artificial neural networks (ANNs) for neuromorphic computing systems, owing to their excellent electronic performance, high integration density, and low cost. ... -
Kinetics of Guided Growth of Horizontal GaN Nanowires on Flat and Faceted Sapphire Surfaces
(MDPI, 2021-03-01)The bottom-up assembly of nanowires facilitates the control of their dimensions, structure, orientation and physical properties. Surface-guided growth of planar nanowires has been shown to enable their assembly and alignment ... -
Advantageous Description of Short Fatigue Crack Growth Rates in Austenitic Stainless Steels with Distinct Properties
(MDPI, 2021-03-01)In this work two approaches to the description of short fatigue crack growth rate under large-scale yielding condition were comprehensively tested: (i) plastic component of the J-integral and (ii) Polak model of crack ... -
The Impact of Vibrational Entropy on the Segregation of Cu to Antiphase Boundaries in Fe3Al
(MDPI, 2021-08-02)We performed a quantum mechanical study of segregation of Cu atoms toward antiphase boundaries (APBs) in Fe3Al. The computed concentration of Cu atoms was 3.125 at %.The APBs have been characterized by a shift of the lattice ... -
Electron beam directed etching of hexagonal boron nitride
(Royal Society of Chemistry, 2016-09-28)Hexagonal boron nitride (hBN) is a wide bandgap van der Waals material with unique optical properties that make it attractive for two dimensional (2D) photonic and optoelectronic devices. However, broad deployment and ... -
Colossal magnetic phase transition asymmetry in mesoscale FeRh stripes
(Springer Nature, 2016-10-11)Coupled order parameters in phase-transition materials can be controlled using various driving forces such as temperature, magnetic and electric field, strain, spin-polarized currents and optical pulses. Tuning the material ... -
Magneto-optical investigations of molecular nanomagnet monolayers
(Royal Society of Chemistry, 2016-04-11)We report field-dependent magnetization measurements on monolayers of [Dy(Pc)2] on quartz, prepared by the Langmuir–Blodgett technique. The films are thoroughly characterized by means of X-ray reflectivity and atomic force ... -
Preparation of (001) preferentially oriented titanium thin films by ion-beam sputtering deposition on thermal silicon dioxide
(Springer US, 2016-04-01)We propose the ion-beam sputtering deposition providing Ti thin films of desired crystallographic orientation and smooth surface morphology not obtainable with conventional deposition techniques such as magnetron sputtering ... -
Plasmonic Metasurface Resonators to Enhance Terahertz Magnetic Fields for High-Frequency Electron Paramagnetic Resonance
(Wiley-VCH, 2021-09-15)Nanoscale magnetic systems play a decisive role in areas ranging from biology to spintronics. Although, in principle, THz electron paramagnetic resonance (EPR) provides high-resolution access to their properties, lack of ... -
Entropy-Driven Grain Boundary Segregation: Prediction of the Phenomenon
(MDPI, 2021-08-01)The question is formulated as to whether entropy-driven grain boundary segregation can exist. Such a phenomenon would be based on the assumption that a solute can segregate at the grain boundary sites that exhibit positive ... -
Effect of Underload Cycles on Oxide-Induced Crack Closure Development in Cr-Mo Low-Alloy Steel
(MDPI, 2021-05-01)Underload cycles with small load amplitudes below the fatigue crack growth threshold are dominantly considered as insignificant cycles without any influence on fatigue lifespan of engineering structural components. However, ... -
Fatigue characterization of polyethylene under mixed mode I/III conditions
(Elsevier, 2021-04-01)Mixed mode I/III fatigue fracture behaviour of bulk polymers is scarcely investigated. Thus, the aim of this work is to focus on the comparison of pure mode I and mixed mode I/III fatigue loading of polyethylene. During ... -
Effect of Solution Annealing on Fatigue Crack Propagation in the AISI 304L TRIP Steel
(MDPI, 2021-03-01)Fatigue crack propagation in near-threshold regime was studied in the 304L austenitic stainless steel in two microstructural states: as-received (AR) with finer microstructure and low susceptibility to the transformation-induced ... -
Temperature Dependence of Fracture Characteristics ofVariously Heat-Treated Grades of Ultra-High-Strength Steel:Experimental and Modelling
(MDPI, 2021-10-07)The temperature dependence of tensile characteristics and fracture toughness of the standardly heat-treated low-alloyed steel OCHN3MFA along with three additionally heat-treated grades was experimentally studied. In the ... -
Stabilizing Single Ni Adatoms on a Two-Dimensional Porous Titania Overlayer at the SrTiO3(110) Surface
(ACS Publications, 2014-08-02)Nickel vapor-deposited on the SrTiO3(110) surface was studied using scanning tunneling microscopy, photoemission spectroscopy (PES), and density functional theory calculations. This surface forms a (4 x 1) reconstruction, ... -
Influence of primary beam energy on localized surface plasmon resonances mapping by STEM-EELS
(Cambridge University Press, 2021-07-30)We have discussed the impact on experimental characteristics which are important to detect localized surface plasmon peaks in EELS successfully, namely: the intensity of plasmonic signal, the signal to background ratio, ... -
The Effect of Hydrogen on the Stress-Strain Response in Fe3Al: An ab initio Molecular-Dynamics Study
(MDPI, 2021-07-26)We performed a quantum-mechanical molecular-dynamics (MD) study of Fe3Al with and without hydrogen atoms under conditions of uniaxial deformation up to the point of fracture. Addressing a long-lasting problem of hydrogen-induced ... -
Single-Shot Three-Dimensional Orientation Imaging of Nanorods Using Spin to Orbital Angular Momentum Conversion
(American Chemical Society, 2021-08-25)The key information about any nanoscale system relates to the orientations and conformations of its parts. Unfortunately, these details are often hidden below the diffraction limit, and elaborate techniques must be used ... -
Experimental and Numerical Investigation of Thermomechanical Cycling of Notched NiTi Shape Memory Ribbon Using SMA Model Accounting for Plastic Deformation
(Elsevier, 2021-09-07)Shape memory alloys (SMAs) are being increasingly applied as thermally driven actuators. The commercially available SMA elements, however, frequently contain stress risers, either due to internal or surface defects or due ... -
Spin wave propagation in corrugated waveguides
(AIP Publishing, 2021-03-01)Curvature-induced effects allow us to tailor the static and dynamic response of a magnetic system with a high degree of freedom. We study corrugated magnonic waveguides deposited on a sinusoidally modulated substrate ...