Analýza mechanických vlastností plastových dílů realizovaných 3D tiskem
Analysis of the mechanical properties of plastic parts realized by 3D printing
Author
Advisor
Vosynek, PetrReferee
Benešovský, MarekGrade
AAltmetrics
Metadata
Show full item recordAbstract
Tato bakalářská práce se zabývá analýzou mechanických vlastností vzorků z materiálu PET-G vytvořených pomocí 3D tisku. Problém byl řešen experimentálně. Vzorky byly vytištěny pomocí metody tisku FDM (Fused Deposition Modeling). Měření mechanických vlastností proběhlo pomocí zkoušky tahem a naměřené veličiny byly dále statisticky analyzovány. Zkoumaný byl vliv pigmentu, výrobce materiálu a vliv nastavení procesních parametrů při samotné stavbě vzorků. Na základě vykonaných analýz bylo zjištěno, že největší vliv na výslednou pevnost v tahu měla orientace součásti při tisku. Nejlepších mechanických vlastností dosahovaly vzorky tištěné horizontálně v rovině XY s úhlem výplně 45° / - 45° od výrobce Devil Design. This bachelor thesis deals with the analysis of mechanical quantities of PET-G samples which were created by using 3D printing. The problem was solved experimentally. The samples were printed by using the FDM technology (Fused Deposition Modeling). Mechanical properties were measured by the tensile test and the measured quantities were further analyzed statistically. The influence of the pigment, the material manufacturer and the effect of setting the process parameters on the actual construction of the samples were investigated. On the basis of the carried out analyses it was discovered that the samples printed horizontally in the XY plane with a 45° / -45° fill angle from Devil Design had the best mechanical properties.
Keywords
materiál PET-G, 3D tisk, FDM technologie, tahová zkouška, pevnost v tahu, modul pružnosti, PET-G material, 3D printing, FDM technology, tension test, tensile strength, modulus of elasticityLanguage
čeština (Czech)Study brunch
Základy strojního inženýrstvíComposition of Committee
Ing. Lubomír Junek, Ph.D. (předseda) doc. Ing. Jana Horníková, Ph.D. (místopředseda) doc. Ing. Miroslav Suchánek, CSc. (člen) doc. Ing. Vladimír Fuis, Ph.D. (člen) doc. Ing. Tomáš Návrat, Ph.D. (člen) Ing. Petr Marcián, Ph.D. (člen) Ing. Lubomír Houfek, Ph.D. (člen) doc. Ing. Zdeněk Hadaš, Ph.D. (člen) Ing. Michal Vajdák (člen)Date of defence
2017-06-21Process of defence
Posluchačka představila běhen asi 10 minut svou bakalářskou práci. Dále odpověděla na všechny otázky oponenta a dalších členů komise.Result of the defence
práce byla úspěšně obhájenaPersistent identifier
http://hdl.handle.net/11012/66267Source
KREJBYCHOVÁ, A. Analýza mechanických vlastností plastových dílů realizovaných 3D tiskem [online]. Brno: Vysoké učení technické v Brně. Fakulta strojního inženýrství. 2017.Collections
- 2017 [607]