Optimization of cementitious composite for heavyweight concrete preparation using conduction calorimetry

The present work investigates the hydration heat of different cement composites by means of conduction calorimetry to optimize the composition of binder in the design of heavyweight concrete as biological shielding. For this purpose, Portland cement CEM I 42.5 R was replaced by a different portion of supplementary cementitious materials (blast furnace slag, metakaolin, silica fume/limestone) at 75%, 65%, 60%, 55%, and 50% levels to obtain low hydration heat lower than 250 j g(-1). All ingredients were analyzed by energy dispersive X-ray fluorescence (EDXRF) and nuclear activation analysis (NAA) to assess the content of major elements and isotopes. A mixture of two high-density aggregates (barite and magnetite) was used to prepare three heavyweights concretes with compressive strength exceeding 45 MPa and bulk density ranging between 3400 and 3500 kg m(-3). After a short period of volume expansion (up to 4 h), a slight shrinkage (max. 0.3 degrees/degrees degrees) has been observed. Also, thermophysical properties (thermal conductivity, volumetric specific heat, thermal diffusivity) and other properties were determined. The results showed that aggregate content and not binder is the main factor influencing the engineering properties of heavyweight concretes.

Keywords

Cementitious composites, Hydration heat, Heavyweight concrete, Aggregates, Radioactive isotope, Mechanical properties, Thermophysical properties

Citation

Journal of Thermal Analysis and Calorimetry. 2020, vol. 142, issue 1, p. 255-266.
https://link.springer.com/article/10.1007/s10973-020-09530-0

Document type

Peer-reviewed

Document version

Accepted version

Language of document

en

Document licence

(C) Springer